Lost communication with parking sensors
Where to start
No communication with the parking sensor module. Harmless for driving but irritating: the sensors either go silent or beep for no reason. The usual culprit is a connector in the bumper — after a pressure wash, a light parking knock or a bumper change where the plug was not clicked fully home. ⚠️ Check on a dry car: moisture in the connector gives a wandering code that clears itself by the evening and comes back after the next wash.
«No communication» is about the bus, not the unit
⛔ «No communication» almost never means «the unit is broken». It means one unit stopped hearing another, and the usual causes are power, ground and the bus — not the unit itself. Replacing a control unit on this code is the most expensive mistake in the whole reference.
Read the number of them. Several «no communication» codes at once point to something shared: power, ground, or a break in the bus. One code alone points to that unit's own connector and its power. Five missing units almost never mean five broken units.
⚠️ These codes also appear on their own after the battery has been disconnected, and clear themselves after a few trips. Clearing them without finding the cause is fine only in that case — otherwise they come back before you leave the yard.
How to put together a report a mechanic will actually read
How the code is built
All codes in «Communication between modules»
How the app helps
CarScan reads this code from your car through an OBD-II adapter, shows whether it is active now or only stored, names the module that reported it, and puts it into a plain-text report for your mechanic.